產品代號：170美線micro
不卡屏 不跳屏 HTC新型號都合適
標準輸出不影響電池壽命
短路保護：當充電器輸出端短路時，輸入功率小于3W.當短路解除時充電器恢復正常充電。
輸入保護: 充電器的保險絲為1A 250V。當輸入電流過大時，保險絲會自動溶斷，從而切斷電源，充電器無輸出，充電器不能自動恢復正常工作，從而保護手機的正常。
BuKa screen not jump screen all models have appropriate new HTC
standard output does not affect the battery life
Short circuit protection: when charger output shorted, the input power is less than 3 w. when short circuit faults remove charger back to normal when charging.
Input protection: charger for 1 A fuse 250 V. When the input current is too large, the fuse will automatically dissolve broken, and cut off power charger without output, the charger can not be automatically resume normal work, in order to protect the normal cell phone.
一、電氣特性：
使用環境：溫度 －10℃～+40℃,濕度 0～95%。
儲藏環境：-25℃～+70℃。
測試溫度：25℃。
輸入?yún)?shù)：AC100～240V 47-63Hz 0.15A（MAX）；
輸出電壓：DC 4.95V-5.25V（空載）。
輸出負載電壓/電流：4.75V-5.25V 1A Max
短路保護：當充電器輸出端短路時，輸入功率小于3W.當短路解除時充電器 恢復正常。
輸出過壓保護：當輸出電壓過額定電壓的130%∽160%時,電源將保護，故障排除后不能恢復正常工作。
輸入保護: 充電器的保險絲為1A 250V。當輸入電流過大時，保險絲會自動溶斷，從而切斷電源，充電器無輸出，充電器不能自動恢復正常工作。
效率：≥65%
二、跌落試驗：
在1. 0米高度上，將充電器以不利的方向跌落到木板上，做5次試驗。要求：充電器無裂縫（裂開），無部件松動；電氣測試后，各項電氣指標要求。
三、振動試驗：
振動試驗方法：頻率為10~50Hz，振幅為0.35mm,每個方向上掃頻循環次數為10次。試驗后外觀和電氣性能指標要求。
四、環境技術條件：
1、 溫度
■操作溫度：-10∽+40℃,在該溫度范圍內使用，應不會出現出指標要求的現象。
■儲存溫度：-25℃∽+70℃
2、 潮濕性
將旅行充電器置于+35℃濕度90%+/-5%的環境中48h，充電器各項性能指標應不改變，外觀，無銹蝕現象，開裂。
A, electrical properties:
Use environment: temperature-10 ℃ ~ + 40 ℃, humidity 0 ~ 95%.
Storage environment: 25 ℃ ~ +-70 ℃.
Test temperature: 25 ℃.
Input parameters: AC100 ~ 240 V 47-63 Hz 0.15 A (MAX);
Output voltage: DC 4.95 V to 5.25 V (no-load).
Output voltage/current load: 4.75 V to 5.25 V 1 A Max
Short circuit protection: when charger output shorted, the input power is less than 3 w. when short circuit faults remove the charger when back to normal.
Output over-voltage protection: when the output voltage of more than 130% of the rated voltage ∽ 160%, the supply will protect, and troubleshooting cannot resume normal work after.
Input protection: charger for 1 A fuse 250 V. When the input current is too large, the fuse will automatically dissolve broken, and cut off power charger without output, the charger can not be automatically resume normal work.
Efficiency: acuity 65%
Second, drop test:
In 1. 0 meters high, with the most unfavorable will charger direction fell to board, and do 5 times test. Requirements: charger without cracking (cracked), no loose parts; Electrical testing, the electrical index can meet the requirements.
Three, vibration test:
The vibration test methods: for 10 to 50 Hz ac frequency, amplitude of 0.35 mm, each direction sweep frequency cyclic number for 10 times. After test appearance and electrical properties can meet the index requirements.
Four, environmental technology conditions:
1, temperature
S operating temperature: ℃, ∽ + 40 in the temperature range use, should not appear beyond the requirements of the index phenomenon.
S storage temperature:-25 ℃ ∽ + 70 ℃
2, moisture resistance
Will travel charger in ℃ + 35 humidity 90% + /-5% of the environment in 48 h, charger various performance indicators should not change, nondestructive appearance, no rust corrosion cracks.
